Pod uslovom da je igla urađena od oplate Enterprajza pa je neće saviti :)
Jedan od boljih no-sweat sajtova na temu kućne radinosti...
http://www.execulink.com/~dtierney/wmc/
Q. 7 How can I get my @*&$* grips off and on easily?
Ahhh no sweat. It's easy, and removing your grips takes a few seconds and not hours of struggling. Remove your bar ends (if you have them) and bar plugs. Get a long thin screwdriver (mine has a 6" x 3/16" dia blade) and rub it with liquid soap or spray it with WD-40.
Pass it all the way under the grip (make sure you don't poke it up thru the grip!) so it sticks out on the brake lever end.
Dakle, uzmeš podmazan šrafciger - a možeš i primereno tanak imbus sa dovoljno dugom drškom, uguraš ga kroz onu rupicu na kraju drške, provučeš između drške i upravljača, okreneš, kraj
Now, using the end of the bar as a fulcrum (pivot), twirl the screwdriver around the bar, under the grip. As you make a full circle, grab the grip with the same hand you have the screwdriver in and pull the grip off all in one motion - so it's push - twirl - pull. That's about five seconds worth of time. Far easier and quicker than using compressed air or injecting mysterious concoctions under the grips eh?
To replace the grip, soak the grip in hot water for a few minutes, (wash out the WD-40 with soapy water if you used it), have the bike sitting with the opposite handlebar end resting against a wall, wet the exposed handlebar where the grip is going, working quickly take the grip out of the hot water and slide it onto the bar. It will take a goodly amount of force but it will go on better if you don't let it rest - keep it moving up that bar until it's in the right spot.
When it's dry it will be on there reeeeeeeel good. If the grip loosens up after a while, you might be a candidate for sticking it on with hairspray or spray-can paint.
That wasn't too hard was it?[/i][/b]